O&O Software DiskRecovery 7 Admin Edition Guide de l'utilisateur télécharger pdf (Page 27)

Getting started

O&O DiskRecovery-23

Applying a filter

Select target folder

To recover selected files you need to enter a saving location. By default your 'My Documents' folder is set,

but any folder, including network folders, may be selected for this. O&O DiskRecovery automatically creates a sub-

folder into which the recovered files are saved. Because an individual subfolder is created for every file type recovered,

it is advised that you select a target folder that is new or empty. In addition, it is possible to create a report regarding the

completed data recovery.

l Enter the target folder for the data to be rescued. If it does not exist yet, it will be created automatically. Confirm

the corresponding dialogue question.

l Click Next to initiate the recovery of data.

Note: Please bear in mind that the target folder cannot be located on the same partition from where the data is to be

restored! Also do not forget to make sure you have enough storage capacity on disk to facilitate the newly recovered

files. If you only have one partition (e.g. only "C:"), you will need an external disks to save the data to be restored,

e.g. USB Stick.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 64 65

Pas de commentaire

O&O Software DiskRecovery 7 Admin Edition Guide de l'utilisateur Page 27